Rear Bumper Removal/Installation

Rear Bumper Removal/Installation

NOTE:

- Have an assistant help you when removing and installing the rear bumper.
- Put on gloves to protect your hands.
- Take care not to scratch the rear bumper or the body.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

1. Remove the bolts (A, B) and the screws (C), and detach the clips (D).

NOTE: To release the clips, pry up on the center pin at the notch (E).






2. Pull the rear bumper (A) at the wheel arch areas to release it from the hooks (B) (nine places) on the side spacers (C).






3. With the help of an assistant, pull the rear bumper (A) to release it from the hooks (B) (six places). Disconnect the rear bumper subharness connectors (C) (for some models).





4. If necessary, remove the absorber (D).

5. Install the bumper in the reverse order of removal, and note these item:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Make sure the rear bumper engages the hooks on both side brackets and both side spacers securely.
- Push the clips and the hooks into place securely.