Operation CHARM: Car repair manuals for everyone.

Audio Display Visor Removal/Installation




Audio Display Visor Removal/Installation

NOTE:

- Do this procedure in a clean place free from dirt.
- Wear latex or vinyl gloves when doing this procedure (Do not use fabric gloves).
- When removing the audio display visor, do not touch the LCD facing.
- If there is dirt on the LCD facing, clean it using compressed air.
- When installing the audio display visor onto the LCD assembly, be careful not to touch the LCD facing.
- Check that the audio display visor and the LCD assembly are properly installed.
- Since the LCD assembly and the audio display visor are installed at an angle, be sure that the screws are properly seated. If not properly seated, tighten the screws.
- Check that the audio display unit assembly has no damage.
- When removing the audio display visor, do not hold the LCD facing down.

1. Remove the audio display-USB adapter control unit Audio Display-USB Adapter Control Unit Removal/Installation.

2. Remove the screws and the LCD assembly (A) from the audio display visor (B).





3. Install the audio display visor reverse order of removal.