Driver's Power Seat Motor Test (Without DPMS)

Driver's Power Seat Motor Test

Driver's Seat without DPMS

NOTE:

- SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service Precautions before doing repairs or servicing.
- For DPMS power seat motor test Driver's Power Seat Motor Test (With DPMS)

1. Remove the driver's seat recline cover Front Seat Recline Cover Removal/Installation.

2. Disconnect the 12P connector (A) from the power seat adjustment switch (B).






3. At the 12P connector of the driver's seat wire harness side, test the motor by applying battery power and ground to the terminals according to the table.

Slide motor





Recline motor





Front up-down motor





Rear up-down motor





4. If the motor does not run or fails to run smoothly, go to step 5.

5. Disconnect the 5P or the 2P connector from each motor.

NOTE:

- For the recline motor, turn over the seat-back cover as needed Service and Repair.
- All connector views are wire side of female terminals.









6. Check for continuity between each motor's 5P or 2P connector and the driver's seat wire harness 12P connector. If there is continuity, replace the appropriate motor:

- Slide motor Front Seat Slide Motor Replacement
- Front up-down motor/seat frame Front Seat Frame Replacement
- Rear up-down motor/seat frame Front Seat Frame Replacement
- Recline motor Front Seat Recline Motor Replacement

NOTE: Replace the front or rear up-down motors/seat frame as an assembly.