Power Lumbar Support Switch Test/Replacement

Power Lumbar Support Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service Precautions before doing repairs or servicing.

1. Remove the driver's recline cover Front Seat Recline Cover Removal/Installation.

2. Disconnect the 5P connector from the lumber support switch (A), then separate the cover (B).






3. Check for continuity between the terminals in each switch position according to the table.





*: There is continuity without operating a switch.

4. If the continuity is not as specified, replace the switch.

5. Install the switch in the reverse order of removal.