Driver's Power Seat Adjustment Switch Test/Replacement

Driver's Power Seat Adjustment Switch Test/Replacement

Driver's Seat without DPMS

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service Precautions before doing repairs or servicing.

1. Remove the driver's seat recline cover Removal and Replacement.

2. Disconnect the 12P connector from the power seat adjustment switch (A).





3. Remove the power seat adjustment switch knobs (B) and remove the two screws, then remove the switch.

4. Reinstall the adjustment switch knobs to the switch.

5. Check for continuity between the terminals in each switch position according to the table.





6. If the continuity is not as specified, replace the switch.

7. Install the switch in the reverse order of removal.