Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement (5-Speed A/T)

Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement

Special Tools Required

- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 62 x 68 mm 07746-0010500
- Bearing Driver Attachment, 72 x 75 mm 07746-0010600

1. Remove the oil seal from the torque converter housing.






2. Remove the mainshaft bearing and the oil seal using the 25-40 mm adjustable bearing puller and a commercially available 3/8 ''-16 slide hammer (A).






3. Install the bearing until it bottoms out in the torque converter housing using the driver handle and the 62 x 68 mm bearing driver attachment.






4. Install the oil seal flush into the torque converter housing using the driver handle and the 72 x 75 mm bearing driver attachment.

NOTE: Do not drive the oil seal into the torque converter housing until it bottoms out, it will block the fluid return passage and cause transmission damage.