Shift Lock Stop/Shift Lock Stop Cushion Replacement (5-Speed A/T)

Shift Lock Stop/Shift Lock Stop Cushion Replacement

NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.

1. Remove the shift lever assembly Shift Lever Removal (5-Speed A/T).

2. Remove the shift lever knob Shift Lever Knob And Shift Lever Knob Cover Replacement (5-Speed A/T).

3. Remove the A/T gear position indicator panel light socket (A) from the indicator panel (B).





4. Remove the A/T gear position indicator panel assembly by expanding the four lock tabs (C) from the shift lever assembly (D).

5. Remove the harness wire tie (A), and disconnect the D3 switch connector (B).






6. Remove the A/T gear position indicator panel assembly (A), the shift lever ring (B), and the D3 switch (C) from the shift lever assembly.






7. Remove the shift lock release (A) and release spring (B) by pressing the lock tab (C).






8. While release the lock tab (A) using a screwdriver, insert a pin (B) into the guide hole (C), and push the shift lock solenoid (D) out.





9. Disconnect the shift lock solenoid connector (E).

10. Remove the shift lock stop/stop cushion (F).

11. Replace the shift lock stop/stop cushion.

12. Install the shift lock stop/stop cushion over the mounting pin (G) on the shift lever assembly.

13. Connect the shift lock solenoid connector.

14. Install the shift lock solenoid, the solenoid plunger (H), and the plunger spring (I) assembly.

15. Install the shift lock solenoid by aligning the joint of the solenoid plunger with the tip of the shift lock stop, then push the shift lock solenoid into the shift lever securely.

16. Install the shift lock release spring and the shift lock release.

17. Install the A/T gear position indicator panel assembly (A), the shift lever ring (B), and the D3 switch (C) to the shift lever assembly.






18. Connect the D3 switch connector (A). Route the D3 switch harness (B) and the A/T gear position indicator panel light harness (C) along with the shift lever assembly, and tie the harnesses at the guide (D) with the harness wire tie (E)






19. Install the A/T gear position indicator panel assembly (A) on the shift lever assembly by aligning the four lock tabs (B).





20. Install the A/T gear position indicator panel light socket (C) in the indicator panel.

21. Install the shift lever knob Shift Lever Knob And Shift Lever Knob Cover Replacement (5-Speed A/T).

22. Install the shift lever assembly Shift Lever Removal (5-Speed A/T).