Manufacturer Code Charts: 1410

Navigation System DTC Troubleshooting: 1410

DTC 1410:

Audio Error 10 (RES Error)

NOTE:

- Check the vehicle battery condition first Battery Test.
- This navigation DTC sets when a mechanical malfunction in the rear controller and screen is detected.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How To Troubleshoot The Navigation System.

1. Check that the temperature is between -4 °F(-20 °C), below 158 °F (70 °C) around the rear controller and screen.

2. Clear the hard error code.

3. Turn the ignition switch to LOCK (0), and then back to ON (II).

4. Check for the hard error code.

Is DTC 1410 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the audio-navigation unit Audio-Navigation Unit Removal/Installation.

5. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode.

6. Select the RES in the System Links.

Is Connection OK indicated?

YES -

Replace the rear controller and screen Service and Repair.

NO -

Do the DTC 2708 troubleshooting 2708.