Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2012 >> Pilot 4WD V6-3.5L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Seat Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Position Sensor: Service and Repair




Driver's Seat Position Sensor Replacement

Removal (Power Seat)

NOTE:

- Removal of the driver's seat position sensor must be done according to Precautions and Procedures Service and Repair.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Raise the seat all the way up.

2. Remove the driver's seat Front Seat Removal/Installation.

3. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).





4. Remove the TORX nut (C) using a TORX E12 socket, then remove the driver's seat position sensor.

Installation (Power Seat)

NOTE:

- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

1. Install the driver's seat position sensor with a new TORX nut (A) using a TORX E12 socket, then connect the driver's seat wire harness 2P connector (B) to the driver's seat position sensor (C).





2. Reinstall the driver's seat Front Seat Removal/Installation.

3. Do the battery terminal reconnection procedure Battery Terminal Disconnection And Reconnection.

4. Clear any DTCs with the HDS.

5. Check the operation of the driver's seat position sensor with the HDS Testing and Inspection.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II); and check that the SRS indicator comes on for about 6 seconds and then goes off.

Removal (Manual Seat)

NOTE:

- Removal of the driver's seat position sensor must be done according to Precautions and Procedures Service and Repair.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Raise the seat all the way up.

2. Remove the driver's seat Front Seat Removal/Installation.

3. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor (B).





4. Using a TORX T30 bit, remove the TORX bolt (C), then remove the driver's seat position sensor.

Installation (Manual Seat)

NOTE:

- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

1. Install the driver's seat position sensor with a new TORX bolt (A), then connect the seat position sensor harness 2P connector (B) to the driver's seat position sensor (C).





2. Reinstall the driver's seat Front Seat Removal/Installation.

3. Do the battery terminal reconnection procedure Battery Terminal Disconnection And Reconnection.

4. Clear any DTCs with the HDS.

5. Check the operation of the driver's seat position sensor with the HDS Testing and Inspection.

6. Confirm proper SRS operation: Turn the ignition switch to ON (II); and check that the SRS indicator comes on for about 6 seconds and then goes off.

pro multis · About Operation CHARM