Removal and Replacement

Starter Removal and Installation

Removal

1. Remove the air intake duct.

2. Do the battery removal procedure Removal and Replacement.

3. Remove the battery base.

4. Remove the harness clamp (A), then disconnect the positive starter cable (B) and the S terminal connector (C) from the starter.





5. Remove the lower radiator hose bracket (D) and the dipstick (E).

6. Remove the two bolts holding the starter, then remove the starter (F) and the gasket (G).

Installation

1. Install the starter (A), then tighten the mounting bolts (B).

NOTE: Always use a new gasket (C).





2. Install the lower radiator hose bracket (D) and the dipstick (E).

3. Connect the positive starter cable (F) and the S terminal connector (G) to the starter, then install the harness clamp (H). Make sure the crimped side of the ring terminal faces away from the starter when you connect it.

4. Install the battery base.

5. Do the battery installation procedure Removal and Replacement.

6. Install the air intake duct.

7. Start the engine to make sure the starter works properly.