Windshield Wiper Motor Replacement

Windshield Wiper Motor Replacement

NOTE:

- Before removal and installation, turn the wiper/washer switch ON to (LO) or (HI) position, then OFF to return the motor shaft to the park position.
- Do not use the wiper/washer switch (INT) position in this step.

Removal

1. Open the hood. Remove the nuts (A) and the windshield wiper arms (B).






2. Remove the cowl covers Service and Repair.

3. Disconnect the 5P connector (A) from the wiper motor.






4. Remove the three bolts (B) and the wiper linkage assembly (C).

5. Separate the linkage (A) from the link (B).






6. Note the link's position (C) on the wiper linkage assembly, then remove the nut (D) and the link from the wiper motor (E).

7. Remove the three bolts, and separate the wiper motor from the linkage (F).

Installation

1. Before installing the motor, connect the 5P connector to the wiper motor, and turn the windshield wiper/ washer switch ON to (LO) or (HI) position, then OFF to return the motor shaft to the park position.

NOTE:

- Do not use the wiper/washer switch (INT) position in this step.
- If necessary, replace any damaged clips.
- Apply multipurpose grease to the moving parts.

2. Install the wiper motor to the wiper linkage assembly in the reverse order of removal.

3. Install the linkage to the wiper motor shaft, then align the wiper linkage assembly.






4. After installation, adjust the wiper arms Adjustments.