92-1x

SRS DTC Troubleshooting: 92-1x

DTC 92-1x ("x" can be 0 thru 9 or A thru F):

Short to Power in the Passenger's Airbag Cutoff Indicator

NOTE:

- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair, General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes, and Battery Terminal Disconnection and Reconnection Procedures.
- '12 model: Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software Testing and Inspection, and retest.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Check for DTCs with the HDS

Is DTC 92-1x indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.

4. Turn the ignition switch to LOCK (0).

5. Disconnect the negative cable from the battery, then wait at least 3 minutes.

6. Disconnect the front passenger's airbag cutoff indicator 6P connector Testing and Inspection.

7. '09-11 models: Disconnect SRS unit connector A (28P) from the SRS unit.

'12 model: Disconnect SRS unit connector A (39P) from the SRS unit.

8. Reconnect the negative cable to the battery.

9. Turn the ignition switch to ON (II).

10. '09-11 models: Measure the voltage between body ground and SRS unit connector A (28P) terminal No. 13.

'12 model: Measure the voltage between body ground and SRS unit connector A (39P) terminal No. 20.

'09-11 models





'12 model





Is there less than 0.2 V?

YES -

Faulty SRS unit or front passenger's airbag cutoff indicator; replace the front passenger's airbag cutoff indicator Testing and Inspection, then clear the DTC, and retest. If the DTC is still present, replace the SRS unit Service and Repair.

NO -

Short to power in the dashboard wire harness; replace the dashboard wire harness, then clear the DTC.