Operation CHARM: Car repair manuals for everyone.
Home >> Hummer >> 2005 >> H2 V8-6.0L >> Repair and Diagnosis >> Maintenance >> Filters >> Air Cleaner Housing >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Air Cleaner Housing: Service and Repair



AIR CLEANER ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE




1. Remove the air intake duct.
2. Disconnect the mass air flow/intake air temperature (MAF/IAT) sensor connector.
3. Loosen the clamp securing the MAF/IAT sensor to the air cleaner assembly.
4. Remove the MAF/IAT sensor.




5. Remove the air cleaner housing fasteners.
6. Remove the air cleaner assembly.

INSTALLATION PROCEDURE




1. Position the air cleaner assembly onto the air cleaner adaptor.
2. Install the fasteners.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the air cleaner housing fasteners to 10 N.m (89 lb in).

3. Secure the air cleaner assembly onto the air cleaner adaptor.




4. Install the MAF/IAT sensor to the air cleaner assembly.

IMPORTANT: If the MAF/IAT sensor is installed backwards, the fuel system goes rich. An arrow (2) cast into the plastic portion of the sensor indicates proper air flow direction. The arrow must point toward the engine.




5. Secure the clamps at the MAF/IAT sensor and the air cleaner assembly.
6. Connect the MAF/IAT connector.
7. Install the air intake duct.
pro multis · About Operation CHARM