Operation CHARM: Car repair manuals for everyone.
Home >> Hummer >> 2005 >> H2 V8-6.0L >> Repair and Diagnosis >> Power and Ground Distribution >> Fuse Block >> Service and Repair >> Instrument Panel Electrical Center or Junction Block Replacement - Left
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Instrument Panel Electrical Center or Junction Block Replacement - Left



INSTRUMENT PANEL ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT - LEFT

REMOVAL PROCEDURE




1. Remove the left side end panel.
2. Remove the knee bolster.
3. Disconnect all the wiring connectors from the fuse block.
4. Remove all the fuses.
5. Remove the turn signal relay from the back of the fuse block.
6. From behind the fuse block, remove the retaining bolt.
7. Insert a screw driver between the fuse block and the wire harness block to separate.
8. Push on the retainers in order to remove the fuse block.
9. Remove the fuse block from the vehicle.

INSTALLATION PROCEDURE
1. Install the fuse block onto the IP assembly till it clicks in place.
2. Install the wire harness block to the back of the fuse block.
3. Install the bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 6 N.m (53 lb in).

4. Install the turn signal relay to the back of the fuse block.
5. Using the wiring diagram on the cover of the fuse panel, install the fuses.
6. Install the electrical connectors.
7. Install the knee bolster.




8. Install the left side end panel.
pro multis · About Operation CHARM