Front Door Window Regulator: Service and Repair

Module Replacement - Front Power Window

Removal Procedure

1. Remove the trim panel. Refer to Trim Panel Replacement - Side Front Door (Front Side Door Trim Panel Replacement) .
2. Remove the water deflector. Refer to Water Deflector Replacement - Front Door (Front Side Door Water Deflector Replacement) .
3. Position the window in a position that allows access to the window clamp bolts.




4. Loosen the fasteners on the window clamps.
5. Position the window in the full up position and tape in place.
6. Disconnect the window motor electrical connector.
7. Remove the 5 fasteners (1) retaining the window module to the door.
8. Remove the window module from the door.



Installation Procedure





1. Place the window module in position in the door.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the 5 fasteners (1) to the window regulator.

Tighten the fasteners to 9 Nm (7 lb ft).

3. Connect the window motor electrical connector.
4. Place the window in the window clamps, and tighten the clamps.

Tighten the clamps to 9 Nm (7 lb ft).

5. Operate the window module to inspect for proper operation.
6. Install the water deflector. Refer to Water Deflector Replacement - Front Door (Front Side Door Water Deflector Replacement) .
7. Install the trim panel. Refer to Trim Panel Replacement - Side Front Door (Front Side Door Trim Panel Replacement) .