Rear Door Window Regulator: Service and Repair
REAR DOORREMOVAL AND INSTALLATION
1. Remove the screw holding the inside door handle trim.
2. Remove the screws holding the door trim panel.
3. Insert a trim panel remover between the trim fasteners and the door trim panel to pry off.
Disconnect the wire connectors from the rear door.
4. Remove the door vapor barrier.
5. Roll the rear door glass down and then remove the bolts holding the rear door glass.
6. Remove the front channel from the rear door.
7. Remove the rear door glass from the rear door module.
8. Remove the rear door glass run and loosen the bolts holding the rear channel to the rear door.
9. Remove the rear channel from the rear door.
10. Remove the rear fixed glass.
11. Disconnect the rod from the exterior handle.
Remove the latch, the wire harness, and the rear door module.
12. Installation is the reverse of removal.
When installing the door vapor barrier, butyl tape should not be placed so it blocks the door trim fastener holes.