Repair Procedures

Removal

1. Disconnect the brake hose(C) from the brake line(A) using a 10mm flare-nut wrench(B).




2. Remove the brake house clip(A) from the brake(B).
3. Remove the connector bolt (C), and disconnect the brake hose from the caliper.

Installation

1. Install the brake hose(A) on the knuckle with 12mm flange bolt (B) first, then connect the brake hose to the caliper with the connector bolt (C) and new sealing washers (D).




2. Install the brake hose (A) on the upper brake hose bracket (B) with a new brake hose clip (C).




3. Connect the brake line (D) to the brake hose.
4. After installing the brake hose, bleed the brake system.