Programming and Relearning

Sensor Initiating Procedure

NOTE:
The sensor's default state will be Storage Auto (High Line).

1. Change the newly installed sensor mode to Normal Fixed Base(Low Line) with the 'TPMS exciter'.





NOTE:
Mode(Status/option) of the sensor installed to the vehicle should be Normal Fixed Base (Low)




2. Read the four sensor's ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).

NOTE:
Note that sensors which were already configured as Base (Low Line) will take longer to read.








3. Connect 'TPMS exciter' to the diagnostic connector.




4. Register the four sensor's ids to the receiver.








5. Cycle Ignition, (wait 15 seconds before turn Ignition back on) then related DTC should be erased from the receiver.

NOTE:
In order for the system to correctly monitor tires for under-inflation, there should be a total of exactly 4 sensors fitted to each of the four driven wheel positions. There should be no other sensors in the vehicle since this could cause the system to monitor the wrong sensors.

CAUTION:
Ensure that there are only 4 sensors in the vehicle.