Ignition Switch: Service and Repair

Inspection








1. Disconnect the ignition switch connector (A) and key warning switch connector (B) from under the steering column.
2. Check for continuity between the terminals.
3. If continuity is not specified, replace the switch.






Replacement

1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel.

3. Remove the ignition switch (A) after loosening the screw with IG ON and disconnecting the 6P connector.




4. Remove the steering column cover.

5. Remove the door warning switch and key illumination lamp (A) after disconnecting the 6P connector.




6. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.




7. Installation is the reverse of removal procedure.