I. Special Instructions For 1995 - Present Sonata
I. Special Instructions For 1995 - Present Sonata:1. Remove the glove box, main lower dash pad assembly, and lower dash pad cover (see appropriate Shop Manual for details).
2. Mark the evaporator casing.
A. Draw a vertical line that is flush with the left edge of the cover plate boss.
B. Measure 3 inches up from the case joint along the vertical line made in step A.
C. Mark a spot to locate the hole to be drilled.
3. Using a 7 mm drill bit, drill a hole shallow enough to just pierce through the evaporator casing at the location marked from step 2.
CAUTION:
Drill only deep enough to pierce the evaporator case.
4. Go to "Gleaning Instructions: All Models" section in this TSB.