Clutch Cover and Disc Assembly

CLUTCH COVER AND DISC




Components

Disassembly
1. Drain the clutch fluid and transaxle gear oil.
2. Remove the transaxle assembly.




3. Insert the special tool (09411-11000) in the clutch disc to prevent the disc from falling.
4. Loosen the bolts which attach the clutch cover to the flywheel in a star pattern. Loosen the bolts in succession, one or two turns at a time, to avoid bending the cover flange.

NOTE: DO NOT clean the clutch disc or release bearing with cleaning solvent.

Clutch Cover Assembly Inspection
1. Check the diaphragm spring end for wear and uneven height. Replace if wear is evident or height difference exceeds the limit.

Limit: 0.5 mm (0.02 inch)

2. Check the pressure plate surface for wear, cracks and color change.
3. Check the rivets for looseness and replace the clutch cover assembly if necessary.

Clutch Disc Inspection
1. Check the facing for loose rivets, uneven contact, deterioration due to seizure, adhesion of oil or grease and replace the clutch disc if defective.




2. Measure the rivet sink and replace the clutch disc if it is out of specification

Limit: 0.3 mm (0.012 inch)

3. Check for torsion spring play and damage and if defective, replace the clutch disc.
4. Clean the splines on the input shaft and install the clutch disc. If the disc does not slide smoothly or if play is excessive, replace the clutch disc and/or the input shaft.

Clutch Release Bearing Inspection

CAUTION: The release bearing is packed with grease. Do not use cleaning solvent or oil.

1. Check the bearing for seizure, damage or abnormal noise. Also check the diaphragm spring contacting points for wear.
2. Replace the bearing if the release fork contacting points are worn abnormally.

Clutch Release Fork Inspection
If there is abnormal wear at the point of contact with the bearing, replace the release fork.

Reassembly




1. Apply multipurpose grease to the release bearing contact surfaces and the release cylinder contact surface of the clutch release fork assembly.

CAUTION: When installing the clutch, apply grease to each part, but be careful not to apply excessive grease; It can cause clutch slippage and judder.




2. Apply multipurpose grease into the groove of the release bearing.

Grease: MOLYWHITE TA No.2




3. Apply multipurpose grease to clutch release lever fulcrum contact surface of the clutch release fork assembly.

Grease: MOLYWHITE TA No.2

4. Clean the surfaces of the flywheel and pressure plate thoroughly with fine sandpaper or crocus cloth, and make certain that all oil or grease has been removed.
5. Apply a small amount of multipurpose grease to the clutch disc splines and input shaft splines.

Grease: MOLYWHITE TA No.2

CAUTION: Do not apply more grease than necessary. Too much grease could cause clutch slip or judder.