Rear Wheel Alignment
REAR WHEEL ALIGNMENT INSPECTIONToe-in
Standard value: 4 [+3/ -1] mm(0.16 [+0.12/ -0.04] inch)
NOTE: The rear suspension (T) mounting bolt should be turned an equal amount on both sides when adjusting. Loosen the rear-side nut prior to adjust the eccentric bolt.
Left wheel: Clockwise direction toe-in
Right wheel: Clockwise direction toe-out
The scale has gradations of approximately 2.4 mm (0.09 inch) (signal side to angle equivalent to 14')
CAUTION: The eccentric bolt should be adjusted within a 90° range left and right from the center position.