Rear Wheel Alignment

TOE-IN
Standard value: 2 ± 2 mm

NOTE: The assist arm mounting bolt (crossmember side) should be turned an equal amount on both sides when adjusting.





Inside direction of the vehicle toe-in
Outside direction of the vehicle toe-out
The scale has gradations of approximately 2.4 mm (14').

CAMBER
Standard value
-30' ± 30' (For general suspension)
38' ± 30' (For high suspension)

NOTE:
1. The rear suspension assembly must be free of worn, loose or damaged parts prior to measuring rear wheel alignment.
2. Camber is pre-set at the factory and cannot be adjusted.
3. If camber is not within the specifications, replace bent or damaged parts.