Ignition Switch: Service and Repair

REMOVAL




1. Disconnect the negative (-) battery terminal.




2. Remove the 2 bolts (A) and disconnect the airbag connector and the horn connector, then remove the airbag module.

CAUTION: Remove the horn pad only for vehicle without airbag.




3. Remove the steering wheel lock nut (A).




4. Remove the steering wheel(A) with special tool (09561-11002}.

CAUTION: Do not hammer on the steering wheel to remove it. Doing so may damage the collapsible mechanism.




5. Remove the steering column shroud after removing 3 screws (A).




6. Remove the 3 screws holding the multi-function switch, then disconnect the wire connector. Remove the multi-function switch assembly.




7. Remove the 5 bolts connecting the steering column shaft (A) and the universal joint (B) as shown in the illustration.
8. Remove the key lock assembly from the steering column shaft.
9. Installation is the reverse of removal.