Correcting Azimuth Indicator

Compass

Correcting Azimuth Indicator
It is needed to correct the error between a current azimuth to terrestrial magnetism sensor and the displayed azimuth in the vehicle position.

How To Correct Azimuth Indicator
1. If you push and hold the M (MODE) switch for less than 4-5 seconds, the azimuth indicator will start blinking with the vehicle's present direction.
2. Slowly rotate the vehicle one turn (360 degrees) within 128 seconds.
The rotation could be made at any direction(left or right) in an open space.
3. When the rotation is finished, the azimuth compass indicator will stop blinking and the error correction is completed.
If the indicator continues to blink, rotate the vehicle a bit more until the blinking stops.
The compass heading will appear after 3 seconds when the correcting error is completed.
4. When a zone number will be displayed after pushing and holding the COMP button for 4 seconds, take off your finger and then push the COMP button again until the zone number which you want is displayed.

Note: Rotate the vehicle one turn (90 degree) as shown in the drawing if the vehicle has no place to rotate.

The Azimuth Compass Indicator Correction Will Be Cancelled:
1. If you press M (MODE) switch for more than 0.5 second.
2. When the vehicle is not rotated within 128 seconds after the blinking of the indicator.

Note: The azimuth may display abnormally in specific places (tunnel, parking lot in building, underground parking lot, near transformer substation, etc.). It is normal and the azimuth is displayed normally when escaping above mentioned places.