Lower Side Moulding / Trim: Service and Repair

SIDE GARNISH AND SIDE SILL REPLACEMENT

NOTE:
- Wrap the blade of a putty knife or flat tip screwdriver with protective tape to prevent damage to the door.
- Be careful not to pry too far or you may bend the garnish.
- Put on gloves to protect your hands.

1. Prepare to remove the garnish from inside the vehicle.
- Remove screws from the front and rear door panel.

2. Remove the clips and screws and gently pry the side garnish (A) or side sill (B) away from the door while removing the adhesive tape.






3. Installation is the reverse of removal.
Replace any damaged clips adhesive tape.