Tightening Torque

Tightening Torque


Cylinder Head





Using 8 mm and 10 mm hexagon wrench, install and tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown.


Intake Manifold
Intake manifold to cylinder head 16 - 23 Nm (160 - 230 kgf-cm, 12 - 17 ft. lbs.)


Camshaft bearing cap bolts 14 - 15 Nm (140 - 150 kgf-cm, 10 - 11 ft. lbs.)


Main Bearing Cap





Install and uniformly tighten the 10 bearing cap bolts(A), in several passes, in the sequence shown.
Retighten the bearing cap bolts by (60° - 65°) in the numerical order shown.


Crankshaft Pulley
Crankshaft pulley bolt 170 - 180Nm (1700 - 1800 kgf-cm, 125 - 133 ft. lbs.)


Flywheel
Tightening torque 120 - 130 Nm (1200 - 1300 kgf-cm, 89 - 96 ft. lbs.)


Drive Plate
Tightening torque 120 - 130 Nm (1200 - 1300 kgf-cm, 89 - 96 ft. lbs.)


Oil Pump





Install the oil pump cover (A) to front case with the 7 screws (B).
Tightening torque 6 - 9 Nm (60 - 90 kgf-cm, 4.4 - 6.6 ft. lbs.)


Water Pump





Install the water pump (B) and a new gasket with the 3 bolts.
Tightening torque 20 - 27 Nm (200 - 270 kgf-cm, 15 - 20 ft. lbs.)