2WD

REAR SUSPENSION ARM





COMPONENTS

REPLACEMENT

[2WD]





1. Remove the trailing arm mounting bolt (A) and suspension arm mounting bolt (B).
2. Remove the opposite side trailing arm mounting bolt and suspension arm mounting bolt.





3. After supporting the rear cross member assembly (B) with the jack (A), remove the cross member mounting bolts and nuts (C).





4. Remove the suspension arm bracket mounting bolts (A).
5. Remove the suspension arm (B).





6. Install the suspension arm bracket mounting bolts (A).





7. Make sure that the arrow mark (B) on the rear cross member (A) should place the front face of the vehicle.
8. Rear suspension arm (C)-to-rear carrier bolts should be temporarily tightened, and then fully tightened with the vehicle on the ground in unloaded condition.
Tightening torque 160 - 180 Nm (1600 - 1800 kgf-cm, 118.0 - 132.8 ft. lbs.)