Campaign - ECM Reprogramming for ESC/ESP System: Overview

Group:
CHASSIS

Number:
06-01-001

Date:
JANUARY, 2006

Model:
2005 & 2006 TUCSON

Subject:
ESC (OR ESP) ECM (ELECTRONIC CONTROL MODULE) REPROGRAMMING PROCEDURE - CAMPAIGN 922

NOTE:
^ ESC = Electronic Stability Control - 2006 Tucson models
^ ESP = Electronic Stability Program - 2005 Tucson models
^ The term ESC will be used interchangeably for ESP in this bulletin.

IMPORTANT:
DEALERS MUST PERFORM THIS CAMPAIGN ON ALL AFFECTED VEHICLES PRIOR TO CUSTOMER RETAIL DELIVERY AND WHENEVER AN AFFECTED VEHICLE IS IN THE SHOP FOR ANY MAINTENANCE OR REPAIR.

IMPORTANT:
WHEN A VEHICLE ARRIVES AT THE SERVICE DEPARTMENT, ACCESS HYUNDAI MOTOR AMERICA'S WARRANTY VEHICLE INFORMATION SCREEN VIA DCS INTERACTIVE OR DCS ON-LINE TO IDENTIFY OPEN CAMPAIGNS.

DESCRIPTION:

All 2005 and 2006 MY Tucson vehicles are equipped with an Electronic Stability Control (ESC).

This bulletin provides a procedure to reprogram the ESC ECM software by using the Hi-Scan Pro to provide enhanced ESC operation during extreme driving conditions.

AFFECTED VEHICLES:
2005 and 2006 Tucson, 2WD & 4WD, vehicles produced through August 12, 2005 that are equipped with ESC (Electronic Stability Control).





ESC ECM Specification Table

CAUTIONS BEFORE REPROGRAMMING:

1. Conduct reprogramming with the ignition key in the "ON" position.

2. Be careful not to disconnect any cables connected to the vehicle or Hi-Scan Pro during reprogramming.

WARNING:
If reprogramming is interrupted, the manual update procedure must be used.

3. Do not start the engine during reprogramming.

4. Do not turn the ignition key OFF during reprogramming.

5. When the reprogramming is completed, turn OFF the ignition key for 20 seconds before starting the engine.

EXPLANATION OF ERROR MESSAGE:

1. "INVALID PASSWORD": Please enter the correct password again.

2. "REPROGRAMMING ERROR, PLEASE WAIT FOR RETRY": An error occurred during reprogramming, the Hi-Scan Pro will retry the reprogramming automatically.

3. "ALREADY REPROGRAMMED" or "INCORRECT TARGET ID": This reprogramming already has been performed on this vehicle or the ESC ECM is not subject to this program.

4. "REPROGRAM ERROR, PLEASE CHECK THE SYSTEM": In this case, the Manual Update Procedure must be used by selecting menu option "02. TUCSON ESP REPROGRAMMING [ERROR]".





WARRANTY INFORMATION