Sunroof / Moonroof: Testing and Inspection

ON-VEHICLE INSPECTION

INSPECT SUNROOF GLASS ALIGNMENT

1. Start the engine and check the operating time of the sunroof.
Operating time: Approx. 5 secs.






2. Check for abnormal noise or bending during operation.
3. With the sunroof fully closed, check for water leakage.
4. The roof panel (A) should be even with the glass (B) weatherstrip (C), to within the standard value "E" all the way around. If not, make the following adjustment.

Standard value "E"
Front edge: 2+0/-1 mm (0.08+0/-0.04 in.)
Rear edge: 2+1/-0 mm (0.08+0.04/-0 in.)






5. If the position is not as specified, lightly loosen the glass adjusting screw (A) to adjust the glass height and tighten it.

Tightening torque: 2.0-3.9 N.m (0.2-0.4 kgf.m, 1.4-2.9 lbf.ft)






6. Check for overlap between the sunroof weatherstrip (A) and the roof panel (B).

Standard value: 1.1 mm