Power Door Lock Actuator: Testing and Inspection
POWER DOOR LOCK ACTUATORS INSPECTIONFRONT DOOR LOCK ACTUATOR INSPECTION
1. Remove the front door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
REAR DOOR LOCK ACTUATOR INSPECTION
1. Remove the rear door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
TAILGATE LOCK ACTUATOR INSPECTION
1. Remove the tailgate trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
FRONT DOOR LOCK SWITCH INSPECTION
1. Remove the front door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check for continuity between the terminals in each switch position according to the table.
REAR DOOR LOCK SWITCH INSPECTION
1. Remove the rear door trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check for continuity between the terminals in each switch position according to the table.
TAILGATE LOCK SWITCH INSPECTION
1. Remove the tailgate trim panel.
2. Disconnect the 6P connector from the actuator.
3. Check for continuity between the terminals in each switch position according to the table.