Shift Linkage: Testing and Inspection
INSPECTIONCHECK POINTS OF SHIFT LOCK SYSTEM
1. With shift lever at P position and brake pedal not depressed. Push button cannot be operated. (Shift lever cannot be shifted to other positions from P) Push button can be operated at the positions except P.
2. With IG key at the position other than "LOCK" (May be at "ACC") and brake pedal stroke 15-25 mm, (With shift lever at P position). Push button can be operated and shift lever can be shifted smoothly to other from P.
3. With brake pedal not depressed. Shift lever can be shifted smoothly to "P" positions from other positions.
4. Brake pedal must be operated smoothly without catching at all positions.
ADJUSTING PROCEDURE FOR "P" SHIFT LOCK CABLE
1. Check that each lock cam is shown.
2. Install shift lock cable in position according to this DWG. In this case, shift lock, cable must be fixed to brake pedal in position.
3. Temporarily install shift lock cable to A/T lever assy as shown. Securely insert cable end into fixing point of shift lock cam.
4. Doing the work of 3. slightly pull outer casing of shift lock cable to direction "E" to stretch cable. In this case, shift lock cam must not move.
5. After checking portion of cable end touches cable fixing pin of shift lock cam. Fix outer casing with a nut.
6. Check the installation condition of the shift lock cam.
CHECK POINTS OF KEY INTERLOCK SYSTEM
1. With IG. KEY at "LOCK" position and brake pedal depressed, push button cannot be operated.
2. IG. KEY must be not turned to "LOCK" position.
3. When shift lever shifted to "P" position again, IG. KEY must be turned to "LOCK" position smoothly.
ADJUSTING AND INSTALL PROCEDURE FOR KEY INTER LOCK CABLE
1. Install key inter lock cable in position according to this drawing.
2. After assembling C/PAD module and inserting the key into the lock cylinder, insert the lock cylinder into the lock body through the C/PAD key hole with "ACC" condition.
3. After assembling key inter lock cable and lock body assembly, fix the key inter lock cable with set screw.
4. Change the key "LOCK" state and check the AT lever is located at "P" position. At this time, slightly push the KEY LOCK CAM to direction "0".
5. After setting the key inter lock cable, fix the cable with nut. At this moment, the key inter lock cable shall not be pulled the direction "Q".