C1334

DTC C1332 SENSOR 1 FAULT
DTC C1333 SENSOR 2 FAULT
DTC C1334 SENSOR 3 FAULT
DTC C1335 SENSOR 4 FAULT

COMPONENT LOCATION
Refer to DTC C1121. C1121

GENERAL DESCRIPTION
Refer to DTC C1121. C1121

DTC DESCRIPTION
This DTC indicates that the sensor has detected that it has an internal fault. The most likely cause is sensor failure.

DTC DETECTING CONDITION





MONITOR SCANTOOL DATA
1. Park the vehicle on a level surface.
2. Connect 'TPMS exciter' or scan tool to Data Link Connector (DLC).





3. Select "TPMS DIAGNOSIS" mode.
4. Select the "FULL" mode of "CURRENT DATA" function.
5. Monitor each sensors temperature parameter on the 'TPMS exciter' or scan tool after 9 minutes.





6. Is parameter normal?

YES
> Fault is intermittent. It has been repaired and TPM receiver module memory is not cleared yet.
> Go to "Verification of vehicle Repair" procedure.

No
> Go to "Component Inspection" procedure.

COMPONENT INSPECTION
1. Turn ON 'TPMS exciter'.
2. Select "TIRE SNSR CONFIG (EXCITER)" mode.
3. Execute "SET SENSOR STATUS" of each wheel.





4. Is data unable to be retrieved for any sensor?

YES
> Check for damaged of TPMS sensor on affected wheel.
> Replace TPMS sensor if necessary and register sensor ID with 'TPMS exciter'.
> Go to "Verification of Vehicle Repair" procedure.

No
> Substitute with a known-good TPM receiver module and check for proper operation.
> If the problem is corrected, replace TPM receiver module and then go to "Verification of Vehicle Repair" procedure.

VERIFICATION OF VEHICLE REPAIR
Refer to DTC C1121. C1121