Turn Signals: Service and Repair

TURN SIGNAL LAMP

REPLACEMENT

REAR COMBINATION LAMP
1. Disconnect the negative (-) battery terminal.
2. Loose the nuts holding the rear combination lamp then disconnect the 4P connector (A) then remove the outside rear combination lamp.






3. Loose the nuts holding the rear combination lamp then disconnect the 4P connector (B) then remove the inner rear combination lamp.






4. Remove the rear garnish after loosening 4 nuts.
5. Remove inner lamp assembly.
6. Installation is the reverse of removal.

SIDE REPEATER (OUTSIDE REAR VIEW MIRROR)
1. Remove the front door quadrant inner cover (A).






2. Disconnect the outside rear view mirror connector from the harness.
3. Remove the outside rear view mirror. after loosening the 3 nuts.






4. Installation is the reverse of removal.