Front Brake Pad Check
FRONT BRAKE PAD CHECK1. Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.
Pad thickness
2. Check that grease is applied, to sliding contact points and the pad and backing metal for damage.
FRONT BRAKE DISC RUN OUT CHECK
1. Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the run out of the disc.
Brake disc run out
Limit: 0.03 mm (0.0012 in.) or less (new one)
2. If the run out of the brake disc exceeds the limit specification, replace the disc, and then measure the run out again.
3. If the run out does not exceed the limit specification, install the brake disc after turning it 180° and then check the run out of the brake disc again.
4. If the run out cannot be corrected by changing the position of the brake disc, replace the brake disc.
