Operation CHARM: Car repair manuals for everyone.
Home >> Hyundai >> 2008 >> Entourage V6-3.8L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Front Impact Sensor (FIS)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front Impact Sensor (FIS)

FRONT IMPACT SENSOR (FIS)

REMOVAL

CAUTION:
- Removal of the airbag must be performed according to the precautions/procedures described previously.
- Before disconnecting the front impact sensor connector, disconnect the front airbag connector (s).
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Disconnect Front Impact Sensor connector.




3. Remove the FIS mounting bolt then remove the Front Impact Sensor.

INSTALLATION

CAUTION:
- Ensure that the harness is installed and routed properly to prevent damage to the wiring.
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1. Install the new Front Impact Sensor with bolt then connect the SRS harness connector to the Front Impact Sensor.

Tightening torque : 1.0 - 1.4 kgf.m (9.5 - 13.6 Nm, 7.0 - 10.0 lb ft)

2. Reconnect the negative battery cable.
3. After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
pro multis · About Operation CHARM