C1208

DTC C1202 FL WHEEL SPEED SENSOR-NO SIGNAL
DTC C1205 FR WHEEL SPEED SENSOR-NO SIGNAL
DTC C1208 RL WHEEL SPEED SENSOR-NO SIGNAL
DTC C1211 RR WHEEL SPEED SENSOR-NO SIGNAL

COMPONENT LOCATION
Refer to DTC C1200. C1200

GENERAL DESCRIPTION
Refer to DTC C1200. C1200

DTC: DESCRIPTION
The ABS ECU monitors the wheel speed sensor signal continuously. This code is set when there is no wheel speed signals within 10 ms to 20 ms at a vehicle speed > 43.2 km/h or a deviation between sensors exceed the threshold or one or two wheels are at 2.75 km/h while the vehicle speed is at 12 km/h. Warning lamp is turned OFF unless additional faults are detected when the IG KEY is turned ON again, and wheel speed is more than 12 Km/h.

DTC DETECTING CONDITION











MONITOR SCANTOOL DATA
1. Engine "ON".
2. Connect scantool to Data Link Connector (DLC)
3. Start and drive vehicle in gear and maintain vehicle speed at or above 50 km/h (31 mph)
4. Monitor the "Wheel Speed Sensor" parameter on the Scantool.





5. Is parameter displayed within specifications?

YES
> Fault is intermittent caused by poor connection in wheel speed sensor harness (FL), Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and then go to "Verification Of Vehicle Repair" procedure.

NO
> Go to "Component Inspection" Procedure.

COMPONENT INSPECTION
Refer to DTC C1201. C1201

VERIFICATION OF VEHICLE REPAIR
After a repair, it is essential to verify that the fault has been corrected.

1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode
2. Using a scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed at or above 50 km/h (31 mph))
4. Are any DTCs present?

YES
> Go to the applicable troubleshooting procedure.

NO
> System performing to specification at this time.