Reassembly

Reassembly

1. Apply a thin coat of multi-purpose grease to the knuckle and bearing contact surface.
2. Using the special tool (09216-21100), press-in the bearing to the knuckle.

NOTE:
- Do not press against the inner race of the wheel bearing because that can cause damage to the bearing assembly.
- Always use a new bearing assembly.




3. Install the snap ring into the groove of the knuckle.
4. Using the special tool (09545-21100), press the hub on to the knuckle.

NOTE:
Do not press against the outer race of the wheel bearing because that can cause damage to the bearing assembly.




5. Tighten the hub to the knuckle to 200 Nm (20 kgf-m, 148 lb-ft) with the special tool (09517-21500).




6. Rotate the hub to seat the bearing.
7. Measure the wheel bearing starting torque.

Standard value
Starting torque : 1.8N.m (0.18kgf.m, 16lb-ft) or less




Fix a dial gauge and measure the hub end play. Check that it is within the standard value.

Standard value
Hub end play : 0.008mm (0.0003in) or less




8. Remove the special tool.
9. Install the disc to the hub.