Component Inspection

Automatic Transaxle

P0716 Input/Turbine Speed Sensor 'A' Circuit Range/Performance - Component Inspection

Component Inspection

1. Ignition "ON" & Engine "OFF".
2. Connect scantool and check DTC.
3. Erase the DTC with scantool.
4. After turning IG OFF to IG ON twice or three times, check DTC again.
5. Does the scantool show same DTC again?






How to perform Initial Learning

If you replace the automatic transmission or Mechatronics (Valve-body + TCM), or if you overwrite the TCU software, be sure to initialize the learned values and perform initial learning.

Step 1) Warm-up
Raise the ATF temperature by leaving the vehicle idling or performing city drive. Check the ATF temperature using the Scan-tool and make sure it is between 50 °C (122 °F) and 120 °C (248 °F). If the ATF temperature is outside this range, work to bring the range.

CAUTION:
Don't raise the oil temperature by stalling the engine.

(Reference)
If the oil temperature is not between 50 °C (122 °F) and 120 °C (248 °F), initial learning can not be performed. Before learning, check for variable speed shock or shift shock.

STEP 2) Driving learning
Select "D" range then depress accelerator pedal smoothly, and keep the APS value 17%, shift gear to 5th gear.
Keep the vehicle speed over 60 kM/h.
In condition that release the accelerator pedal and then depress the brake pedal normally.Stop the vehicle then keep 5 seconds.

STEP 3) Repeat this procedure 10 times.(Not necessary N-D, N-R Learning)