W/Harness Inspection

Automatic Transaxle

P0927 Gear Shift Reverse Actuator Circuit High - W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

1. IG KEY "ON", ENGINE "OFF".
2. Disconnect the "BACK-UP LAMP RELAY".
3. Measure the voltage between power input terminal of "BACK-UP LAMP RELAY" connector and chassis ground.
4. Measure the voltage between coil power terminal of "BACK-UP LAMP RELAY" connector and chassis ground.

Specification : Approx. 12 V




5. Is the measured voltage within the specification?