Daytime Running Lamp: Service and Repair

Removal

1. Disconnect the negative(-) battery terminal.
2. Remove the glove box.

3. Remove the DRL unit (A) after disconnecting the connector and loosening the mounting nut.






Installation

1. Install the DRL unit.
2. Install the glove box.

Inspection

1. Check that the light operate according to the following timing chart.




2. If the daytime running light is not operated well, inspect the connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 3.
3. Make these input tests at the connector
If any test indicates a problem, find and by using ETM correct the cause, then recheck the system.
If all the input tests prove OK, the junction box must be faulty; replace it.