Exterior Moulding / Trim: Service and Repair

Replacement

Roof Rack Replacement

NOTE:
- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the roof rack cover (A).
2. After loosening the mounting nuts, then remove the roof rack (B).




3. Installation is the reverse of removal.

Roof Molding Replacement

NOTE:
- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the roof rack.
2. Using a screwdriver or remover, remove the roof molding (A).




3. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.

Tailgate Garnish Replacement

NOTE:
- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the tail gate trim.

2. Disconnect the connector (A).




3. After loosening the mounting nuts, then remove the tailgate garnish (A).




4. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.

Rear Spoiler Replacement

NOTE:
- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the tailgate trim.

2. After loosening the mounting nuts, then remove the rear spoiler (A)




3. Disconnect the connector (A) and washer nozzle (B).




4. Installation is the reverse of removal.

NOTE:
- Replace any damage clips

Door Side Garnish Replacement

NOTE:
- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface

1. Using a screwdriver or remover, remove the front door garnish (A).
2. Using a screwdriver or remover, remove the rear door garnish (B).




3. Installation is the reverse of removal.

NOTE:
- Replace any damage clips

Side Sill Garnish Replacement

NOTE:
- When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Loosen the mounting screws.
2. Using a screwdriver or remover, remove the side sill garnish (A).
3. Installation is the reverse of removal.

NOTE:
- Replace any damage clips