Repair Procedures
Replacement
Door Scuff Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the door scuff trim (A).
[Front]
[Rear]
2. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
Front Pillar Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. After loosening the mounting screw, then remove the front pillar trim (A).
2. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
Cowl Side Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the front door scuff trim.
2. Remove the hood latch release handle.
3. Remove the cowl side trim (A).
4. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
Center Pillar Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the front door scuff trim and rear door scuff trim.
2. After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
3. Remove the center lower pillar trim (B).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb.ft)
4. Remove the cap, loosen the mounting bolts.
5. Remove the center upper pillar trim (A).
6. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
Rear Pillar Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the rear seat.
2. Remove the rear door scuff trim.
3. Detach the clips and then remove the transverse trim (A).
4. After loosening the mounting bolt, then remove the rear sent belt lower anchor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb.ft)
5. After loosening the mounting bolts, then remove the rear seat bracket (A).
6. Using a screwdriver, remove the lamp (A).
7. Disconnect the connector (B).
8. After loosening the mounting screws, then remove the luggage side trim (C).
9. Disconnect the connector (A).
10. After loosening the mounting bolt and screws, then remove the rear pillar trim (A).
11. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
Luggage Side Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the rear seat.
2. Remove the transverse trim.
3. After loosening the mounting screws, then remove the luggage side trim.
4. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
