Repair Procedures

Removal

1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3. Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
4. Remove the floor console and heater ducts.
5. Pull the lock(1) forward and the pull the lever(3) after presing the lever lock(2).
Disconnect the SRSCM connector (A) and (B).




6. Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove the SRSCM.

Installation

1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3. Install the SRSCM with the SRSCM mounting bolts.

Tightening torque (SRSCM Mounting bolt)
: 8 - 12 N.m (0.8 - 1.2 kgf.m, 5.9 - 8.9 lb-ft)

NOTE:
Use new mounting bolts when replacing the SRSCM after a collision.

4. Connect the SRSCM harness connector.
5. Install the heater ducts and floor console.

6. Connect the DAB, PAB, SAB, CAB and BPT connectors.
7. Reconnect the battery negative cable.
8. After installing the SRSCM, confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.