Repair procedures

Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the front frame inner cover (A).




2. Disconnect the outside rear view mirror connector (A).
3. After loosening the mounting nuts, then remove the outside rear view mirror (B).

Tightening torque :
6.9 - 10.8 N.m(0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)




4. Installation is the reverse of removal.

NOTE:
- Make sure the connector is connected properly.