Pressure Regulating Solenoid: Service and Repair

Inspection

1. Turn ignition switch OFF.
2. Disconnect the E Module connector.
3. Measure resistance between switch signal terminal and switch ground terminal.
4. Check that the resistance is within the specification.

Removal

1. Drain the oil.
2. Disconnector the E-Module connector (A).
(1) Press the rock.
(2) Pull up the lever.




3. Remove the oil pan (A).

Tightening torque :1.4 - 1.6 kgf.m





CAUTION:
Replace the gasket before reinstalling the oil pan.





4. Remove the valve body assembly (A).




5. Disconnect the pressure switch connector (A).




6. Remove the pressure switch (A).

Tightening torque :
0.4 - 0.5 kgf.m (3.9 - 4.9 N.m, 2.88 - 3.6 lb-ft)





Installation

1. Install in the reverse order of removal.

NOTE:
- Adding Automatic Transaxle Fluid(ATF).