Repair Procedures

Removal

1. Remove the driveshaft and axle.

2. Remove the propeller shaft (A).

Tightening torque :
49.0 - 68.6N.m (5.0 - 7.0kgf.m, 36.2 - 50.6lb-ft)




3. Loosen the transfer upper & lower mounting bolts. (transfer side -> transaxle side)








4. Loosen the transfer lower mounting blot. (transaxle side -> transfer side)






Installation

1. Install in the reverse order of removal.

NOTE:
1. Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2. Smear and cover splines (B) with molybdenum type high pressure grease.
TECHLUBE MEGAMAX - ALPHA OR EQUIVALENT




3. Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.