Repair Procedures

Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the cluster fascia panel (A).

3. Remove the cluster (A) from the housing after removing 2 screws.




4. Disconnect the cluster connector (A) and then remove the cluster (B).






Installation

1. Connect the cluster connector.
2. Install the cluster assembly.
3. Install the cluster facia panel.
4. Connect the negative (-) battery terminal.

Inspection

1. Check point (Warning indicator)

















2. Check point (Gauge)





3. Connector terminal check list









4. Communication information





5. Other cluster check list
(1) UMS Setting Mode
There are items (for example Two Turn Unlock, Auto Door Dock/Unlock, In/Out Seat Synchronization, Door Lock Sound, Head Lamp Escort, One Touch Triple Turn, Welcome Light, and Content Setup) that can be set and customized




(2) UMS Setting Procedure
A. Module setting
1 UMS settings are sent to BCM ->
2 Settings are sent via BCM B_CAN to the relevant module ->
3 When the module setting is completed, the current settings are sent to BCM ->
4 The final settings are sent via BCM C-CAN to the dashboard.

Diagnosis with GDS
1. It will be able to diagnose defects of CLU with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis.
2. Select model and "BCM".
3. Select the "Cluster Module" to check.
4. Select "Input/output monitoring", if you will check current data of instrument cluster.
5. If you will check each module data operation forcefully, select "Actuation test".




6. To check the DTC of the each module, select "DIAGNOSTIC TROUBLE CODES".

CLU Variant Coding
After replacing the cluster with a new one, must be performed the "Variant Coding" procedure.
1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.
2. Select model and "BCM".
3. Select Variant coding mode to perform.












4. If the trouble codes occurred when performing variant coding, try the CLU variant coding again after checking the installation status of CLU system.