Tire Pressure Monitor Receiver / Transponder: Service and Repair

Adjustment

1. Disconnect the negative (-) battery cable.
2. Remove the glove box housing.

3. Disconnect the connector.
4. Remove the bracket (B) and receiver (C) as loosen the nut (A-1ea).

Tightening torque :
3.9 - 5.9N.m (0.4 - 0.6kgf.m, 2.9 - 4.3lb-ft)




5. Install in the reverse order of removal.
6. Re-connect battery and turn Ignition on.
7. After replacing the receiver, learn by using self-diagnosis device(GDS).

[Wheel Sensor ID Writing (Wireless) initialization]





[Wheel Sensor ID Writing (Wireless) 1]





[Wheel Sensor ID Writing (Wireless) 2]






Diagnosis procedure by using diagnostic device

As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
1. Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2. Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.

[Vehicle name input initialization]





[Vehicle Name Writing 1]





[Vehicle Name Writing 2]





[Vehicle Name Writing 3]





[VIN input initialization]





[VIN Writing 1]





[VIN Writing 2]





[VIN Writing 3]