Tire Monitoring System: Testing and Inspection

[Wheel Sensor ID Writing (Wireless) initialization]

[Wheel Sensor ID Writing (Wireless) 1]

[Wheel Sensor ID Writing (Wireless) 2]

Diagnosis procedure by using diagnostic device

As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
1. Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2. Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.

[Vehicle name input initialization]

[Vehicle Name Writing 1]

[Vehicle Name Writing 2]

[Vehicle Name Writing 3]

[VIN input initialization]

[VIN Writing 1]

[VIN Writing 2]

[VIN Writing 3]

[Register Sensor function description]

[Preparation phase sensor measurements]

[Sensor register method 1]

[Sensor register method 2]

[Sensor register method 3]

[Sensor register method 4]

[Sensor register method 5]

NOTE:
- Write ID Read ID and be sure to check are the same.
- After registering successfully sensor "Sensor Wireless Information" by the execution determines whether the sensor is working properly.

[Sensor Status initialization]

[Sensor function description]

[Preparation phase sensor measurements]

NOTE:
- In North America, the cable is measured separately.
- In Domestic/General(European) area, the cable is measured without separation.

[Sensor measurements 1]

[Sensor measurements 2]

[Sensor Status]

NOTE:
- Each entry must check whether each sensor normal.
- After replacing the tires or sensors, check the status of sensor is working properly after sensor registration process.